6
(1) Unpack the power supply and verify that the input mode of the power supply is
as required. 从电源模块包装盒中取出电源模块，确认电源模块的输入方式与
所需一致。
(2) Correctly orient the power supply (with the lettering on it upward), grasp the
handle of the power supply with one hand and support its bottom with the other,
and slide the power supply slowly along the guide rails into the slot. Make sure
the latch on the power supply clicks into place. 保证电源模块上下方向正确（电
源模块插入时，请保证电源模块上文字为正向），用一只手握住电源模块上的拉
手，另一只手托住电源模块底部，将其后端对准电源插槽，使电源模块沿电源
插槽水平插入插槽。当电源模块完全插入插槽时，会听到电源模块上的锁闩卡
住插槽的声音。
If the power supply slot has a filler panel, put your finger into the hole in the
filler panel and then pull the filler panel out of the slot gently. 若准备安装电
源模块的电源槽位上有电源假面板，请先拆卸电源假面板。拆卸方法：将
手指伸入圆孔勾住圆孔边缘，沿插槽导轨向外轻微用力拉出假面板。
To Next Page
Loading...
Need help?
General