H3C S5120-EI Series - Protocols and Standards; RRPP Configuration Task List

60
Figure 17 Schematic diagram for an intersecting-ring load balancing network
Protocols and standards
RFC 3619 Extreme Networks' Ethernet Automatic Protection Switching (EAPS) Version 1 is related to
RRPP.
RRPP configuration task list
You can create RRPP domains based on service planning, specify control VLANs and data VLANs for
each RRPP domain, and then determine the ring roles and node roles based on the traffic paths in each
RRPP domain.
Complete the following tasks to configure RRPP:
Task Remarks
Creating an RRPP domain
Required.
Perform this task on all nodes in the RRPP domain.
Configuring control VLANs
Required.
Perform this task on all nodes in the RRPP domain.
Configuring protected VLANs
Required.
Perform this task on all nodes in the RRPP domain.
Configuring RRPP
rings
Configuring RRPP ports
Required.
Perform
this task on all nodes in the RRPP domain.
Configuring RRPP nodes
Required.
Perform this task on all nodes in the RRPP domain
Activating an RRPP domain
Required.
Perform this task on all nodes in the RRPP domain.
Configuring RRPP timers
Optional.
Perform this task on the master node in the RRPP domain.