H3C S5120-EI Series - Activating an RRPP Domain

65
Ste
p
Command
3. Specify the current device as a transit node of the
ring, and specify the primary port and the
secondary port.
ring ring-id node-mode transit [ primary-port
interface-type interface-number ] [ secondary-port
interface-type interface-number ] level level-value
Specifying an edge node
When configuring an edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an edge node.
To specify an edge node:
Ste
p
Command
1. Enter system view.
system-view
2. Enter RRPP domain view.
rrpp domain domain-id
3. Specify the current device as a master node or
transit node of the primary ring, and specify the
primary port and the secondary port.
ring ring-id node-mode { master | transit }
[ primary-port interface-type interface-number ]
[ secondary-port interface-type interface-number ]
level level-value
4. Specify the current device as the edge node of a
subring, and specify the edge port.
ring ring-id node-mode edge [ edge-port
interface-type interface-number ]
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before configuring
the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
To specify an assistant-edge node:
Ste
p
Command
1. Enter system view.
system-view
2. Enter RRPP domain view.
rrpp domain domain-id
3. Specify the current device as a master node or
transit node of the primary ring, and specify the
primary port and the secondary port.
ring ring-id node-mode { master | transit }
[ primary-port interface-type interface-number ]
[ secondary-port interface-type interface-number ]
level level-value
4. Specify the current device as the assistant-edge
node of the subring, and specify an edge port.
ring ring-id node-mode assistant-edge [ edge-port
interface-type interface-number ]
Activating an RRPP domain
To activate an RRPP domain on the current device, enable the RRPP protocol and RRPP rings for the RRPP
domain on the current device.