H3C S5120-SI Series Installation Manual

4-5
Step5 Click Properties in the HyperTerminal window to enter the Switch Properties dialog box. Click the
Settings tab, set the emulation to VT100, and then click OK.
Figure 4-7 Set terminal emulation in Switch Properties dialog box
Booting the Switch
Checking Before Power-On
Before powering on the switch, verify that:
z The power cable is properly connected.
z The power supply voltage meets the requirement of the switch.
z The console cable is properly connected; the terminal or PC used for configuration has been
started; and the configuration parameters have been set.
Powering On the Switch
The S5120-SI series have the same Boot ROM display style. This document uses the Boot ROM output
information on the S5120-28P-SI as an example:
Starting......
************************************************************************
* *
* H3C S5120-28P-SI BOOTROM, Version 107 *
* *
************************************************************************
Creation Date : Feb 11 2009
CPU Type : ARM926

H3C S5120-SI Series Specifications

General

Brand	H3C
Model	S5120-SI Series
Category	Switch
Language	English