H3C S5560X-HI Series User Manual

Figure4-1 SFP+ cable
(1) SFP+ module
(2) Pull latch
IMPORTANT:
•
Ports 1 to 8 on the S6520X-54HC-EI and S6520X-54HC-HI switches do not support GE SFP
transceiver modules or cables.
•
The SFP+ ports on the S6520X-54QC-EI and S6520X-54QC-HI switches do not support the
LSTM1STK cable.
NOTE:
•
As a best practice, use H3C transceiver modules and network cables for the switch.
•
The H3C transceiver modules and network cables
are subject to change over time. For the most
recent list of H3C transceiver modules and cables, contact H3C Support or marketing staff.
•
For the specifications of H3C transceiver modules and network cables, see H3C Transceiver
Modules User Guide.
SFP28 port
The LSWM2ZSP8P and LSWM2ZSP2P interface modules provides SFP28 ports. To connect peer
SFP28 ports over a long distance, use SFP28 transceiver modules and fibers. To connect peer
SFP28 ports over a short distance, use SFP28 cables. You can install SFP28 transceiver modules in
Table4-7 and SFP28 cables in Table4-8 in the SFP28 ports.
Table4-7 SFP28 transceiver modules available for the SFP28 ports
SFP28
transceiver
module
Central
wavelength
(nm)
Connector
Fiber type and
diameter (µm)
Modal
bandwidth
(MHz × km)
Max
transmission
distance
SFP-25G-LR-
SM1310
1310 LC
Single-mode,
9/125
N/A 10 km (6.21 miles)
SFP-25G-SR-
MM850
850 LC
Multi-mode,
50/125
2000 70 m (229.66 ft)
4700 100 m (328.08 ft)
1
2

H3C S5560X-HI Series Specifications

General

Brand	H3C
Model	S5560X-HI Series
Category	Switch
Language	English