34
Parameters
group-id: Specifies a PEX group ID. The value is fixed at 1.
Usage guidelines
To allow user-side ports of different PEXs to join the same aggregation group, you must assign the
cascade ports to which the PEXs are attached to the same PEX group.
If you delete a PEX group, all PEXs in that group will go offline with all settings issued from the parent
device removed.
Examples
# Create PEX group 1 and enter PEX group view.
<Sysname> system-view
[Sysname] pex group 1
[Sysname-pex-group-1]
Related commands
pex-capability enable
pex idle-cascade delete
Use pex idle-cascade delete to delete idle cascade ports.
Syntax
pex idle-cascade delete
Views
System view
Predefined user roles
network-admin
Usage guidelines
After you execute this command on the parent fabric, the system automatically deletes the cascade
ports of which the attached PEXs are offline.
Examples
# Delete idle cascade ports.
<Sysname> system-view
[Sysname] pex idle-cascade delete
Please wait...
All idle PEX-capable Layer 2 aggregate interfaces were deleted.
pex local-forwarding
Use pex local-forwarding to enable PEX local forwarding for a PEX.
Use
undo pex local-forwarding to disable PEX local forwarding for a PEX.
Syntax
pex local-forwarding
undo pex local-forwarding
To Next Page
Loading...
Need help?
General