35
Default
PEX local forwarding is disabled.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only on cascade ports.
If PEX local forwarding is disabled, the PEX sends any incoming traffic to the parent fabric. The
parent fabric makes forwarding decisions and sends the traffic to the outgoing interfaces.
If PEX local forwarding is enabled, the PEX performs local forwarding for Layer 2 unicast packets
with known MAC addresses and reports other packets to the parent fabric for processing.
When you enable or disable PEX local forwarding on a cascade port, the PEX will go offline and then
come online again.
Examples
# Enable PEX local forwarding on Layer 2 aggregate interface 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] pex local-forwarding
Executing this command will cause the PEX to disconnect and then reconnect. Are you sure
you want to continue?[Y/N]: y
pex persistent-forwarding
Use pex persistent-forwarding to enable PEX persistent forwarding for a PEX.
Use
undo pex persistent-forwarding to disable PEX persistent forwarding for a PEX.
Syntax
pex persistent-forwarding
undo pex persistent-forwarding
Default
PEX persistent forwarding is disabled.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only on cascade ports.
For this command to take effect on a PEX, you must enable PEX local forwarding for that PEX.
If PEX persistent forwarding is enabled, the system will not clear the running data or shut down the
network interfaces on the PEX after the PEX goes offline. The PEX can still perform local forwarding.
If PEX persistent forwarding is disabled, the system clears the running data and shuts down all
network interfaces on the PEX after the PEX goes offline. However, the system does not shut down
To Next Page
Loading...
Need help?
General