10
• Do not hold the filler panels, filler panel handles, or the air vents of chassis to carry the chassis. Any
attempt to carry the switch with these parts might cause equipment damage or even bodily injury.
• After placing the switch on the slide rails, do not leave go of your hands immediately because this
might tip the switch. Tipping the switch can cause switch damage and even bodily injury.
Figure 12 Installing the switch in the rack
Grounding the switch
CAUTION:
Connect the
roundin
cable to the
roundin
system in the equipment room. Do not connect it to a fire
main or lightning rod.
Use the provided grounding cable (yellow-green grounding cable).
1
2
2
To Next Page
Loading...
