To Next Page

To Previous Page

2. Place the firewall upside down on the workbench and clean the four round holes in the chassis

bottom with a dry cloth.

3. Attach the four rubber feet to the round holes in the chassis bottom.

4. Place the firewall with upside up on the workbench.

Figure2-2 Mounting the firewall on a workbench

Installing the firewall in a standard 19-inch rack

WARNING

To avoid bodily injury and device damage, use a minimum of two persons to rack-mount the firewall.

CAUTION:

For adequate heat dissipation, ensure a minimum clearance of

80 mm (3.15 in)

around the air inlet

and outlet vents of

the chassis and a distance of 1U (44.45 mm, or 1.75 in) between the

chassis and

other devices in the rack.

Rack-mounting the firewall by using front mounting brackets

The F1000-AI-05 and F1000-AI-15 firewalls support this installation method.

To install the firewall in a standard 19-inch rack by using front mounting brackets:

1. Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably

grounded.

2. Unpack the firewall and accessories.

3. Mark the cage nut installation positions on the rack posts by using the mounting brackets.

4. Install cage nuts.

Other manuals for H3C SecPath F1000-AI-5 Series

Questions and Answers:

Need help?

Do you have a question about the H3C SecPath F1000-AI-5 Series and is the answer not in the manual?

General