H3C WA2600 series User Manual

74
Adding rules to an SNMP view
1. Select Device > SNMP from the navigation tree.
2. Click the View tab.
The page in Figure 62 appears.
3. Click the icon of the target view.
The Add rule for the view ViewDefault window appears.
Figure 65 Add rules to an SNMP view
4. Configure the parameters as described in Table 38.
5. Click Apply.
NOTE:
You can modify the rules of a view in the page you enter by clicking the icon of that view.
Configuring an SNMP community
1. Select Device > SNMP from the navigation tree.
2. Click the Community tab.
The community tab page appears.
Figure 66 Configure an SNMP community
3. Click Add.
The Add SNMP Community page appears.

H3C WA2600 series Specifications

General

Brand	H3C
Model	WA2600 series
Category	Wireless Access Point
Language	English