H3C WX Series Getting Started Guide

11
5 Logging in to an AC
Before logging in to an AC, power on the AC and connect it to a network. For more
information, see Powering on the AC and connecting it to a network.
You can use any of the following methods to log in to a WX series access controller:
Logging in through the console port
Logging in through telnet
Logging in through SSH
Logging in through web-based network management system
Logging in through NMS
Powering on the AC and connecting it to a network
After installing the AC, perform the following steps before logging in to the AC.
NOTE:
To connect the power supply and connect your AC to a network, see the installation guide of the
AC.
1. Power on the AC and connect it to an Ethernet.
2. Check the LEDs on the AC.
3. Power LED. Check the power LED of the AC to see whether the power supply works
normally. For more information, see the installation guide or card manual of your
AC.
4. Ethernet LED. Check the Ethernet LED to see whether the AC is connected to the
Ethernet, and whether data is being transmitted and received. For more
information, see the installation guide or card manual of your AC.
Logging in to an AC
For more information about how to log in to an AC, see Logging In to the AC in the H3C
WX Series Access Controllers Fundamentals Configuration Guide.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English