To Next Page

To Previous Page

[Sysname] configuration encrypt { private-key | public-key }

NOTE:

For the device that supports this feature, you can use the display saved-configuration command

instead of the more command to view the encrypted configuration file, because the latter

cannot decrypt the file. Otherwise, you are prompted for operation failure or garbled characters.

Modes in saving the configuration

You can save the configuration in one of the following two modes:

Fast saving mode: Fast saving mode is implemented by using the save command

without providing the safely keyword. The mode saves the file quickly but is likely to

lose the existing configuration file if the device reboots or the power fails during the

process.

Safe mode. Safe mode is implemented by using the save command with the safely

keyword. The mode saves the file more slowly than the fast saving mode, but can

retain the configuration file on the device even if the device reboots or the power

fails during the process.

The fast saving mode is suitable for environments where power supply is stable. The safe

mode, however, is preferred in environments where stable power supply is unavailable

or remote maintenance is involved.

NOTE:

The configuration file must have extension .cfg

During the execution of the save [ safely ] command, the startup configuration file to be used

at the next system startup may be lost if the device reboots or the power supply fails. In this

case, the device boots with the null configuration. After the device reboots, you must

re-specify a startup configuration file for the next system startup.

To save the current configuration, use either command (available in any view):

1. Required: Save the current configuration to the specified file, but the configuration

file is not set as the file to be used at the next startup.

[Sysname]save file-url

2. Required: Save the current configuration to the root directory of the storage

medium and specify the file as the startup configuration file to be used at the next

startup.

[Sysname]save [ safely ]

H3C WX Series Getting Started Guide

Other manuals for H3C WX Series