To Next Page

To Previous Page

[Sysname]ip address ip-address { mask | mask-length }

5. Optional: Configure the description of the current VLAN. VLAN interface name is

used by default, for example, Vlan-interface1 Interface.

[Sysname]description text

6. Optional: Bring up the VLAN interface. By default, a VLAN interface is in the up

state. In this case, the VLAN interface is up so long as one port in the VLAN is up and

goes down if all ports in the VLAN go down. An administratively shut down VLAN

interface however will be in the down state until you bring it up, regardless of how

the state of the ports in the VLAN changes.

[Sysname]undo shutdown

Configuring WLAN service

WLAN service configuration includes enabling WLAN service, WLAN global configuration,

country code, service template, AP, radio configuration, and interface configuration.

To configure WLAN service:

1. Enter system view.

<Sysname>system-view

2. Required: Enable WLAN service. By default, WLAN service is enabled. All WLAN

services are available only if WLAN service is enabled.

[Sysname]wlan enable

3. Required: Specifies a country code. By default, the country code value is CN. The

country code determines characteristics such as the power level and total number

of channels.

[Sysname]wlan country-code code

NOTE:

You must set the correct country code or area code before configuring an AP.

If you change the country code for an AP that has a radio card not supported by the new

country code, the corresponding WLAN-radio interface will have its configurations of the

service template, maximum power, and channels removed automatically. For more

information about country code and country, see WLAN Service in the WLAN Command

Reference in the H3C WX series access controllers Command References.

Configuring a service template

H3C WX Series Getting Started Guide

Other manuals for H3C WX Series