To Next Page

To Previous Page

Field

Description

interface GigabitEthernet1/0/1

interface GigabitEthernet1/0/2

interface GigabitEthernet1/0/3

interface GigabitEthernet1/0/4

interface Ten-GigabitEthernet1/0/5

The interface type supported by the AC.

Support for the interface types depends on

the AC model.

load xml-configuration

The AC loads the configuration file with

extension .xml after startup.

user-interface con 0

user-interface vty 0 4

authentication-mode scheme

user privilege level 3

The AC supports console and VTY user

interfaces. By default, the authentication

mode for VTY login is AAA, and the user

privilege level is 3.

Configurations for using an AC

Besides the default configurations, you must perform the following configurations to use

an AC in your network:

Specifying an IP address for an AC

Configuring WLAN service

Specifying an IP address for an AC

To specify an IP address for the AC:

1. Enter system view.

<Sysname>system-view

2. Optional: Create VLANs. Using this command can create multiple VLANs in

batches.

[Sysname]vlan { vlan-id1 [ to vlan-id2 ] | all }

3. Required: Create a VLAN interface and enter VLAN interface view. If the VLAN

interface already exists, you enter its view directly. If the VLAN interface does not

exist, you need to create a VLAN and then enter VLAN interface view.

[Sysname]interface vlan-interface vlan-interface-id

4. Required: Assign an IP address to the VLAN interface. IP address 192.168.0.100 is

assigned to VLAN interface 1 by default. No IP address is configured for other VLAN

interfaces.

H3C WX Series Getting Started Guide

Other manuals for H3C WX Series