Haas TR310 - Machine Compatibility and Tools; Applicable Machines and Cable Requirements; Tools Required for Installation

Machine Compatibility
Do this procedure for these machines:
All VMCs
For a TRT100, the machine must have software version M18.24A or higher.
It may be necessary to change a cable in the control on these machines:
Trunnions made after October, 2016:
Mills with Classic Haas Control (CHC) or Next Generation Control (NGC) made before October, 2016:
4th axis scale enabled:
Remove cable CABLE, [+12V] ROTARY SCALE FEEDBACK CONTROL END (CHC) (P/N 32-10065) or
cable CABLE, [+12V] ROTARY SCALE FEEDBACK CONTROL END (NGC (P/N 32-10053) from the control.
Install cable CABLE, [+5VDC) ROTARY SCALE FEEDBACK CONTROL END (CHC,NGC) (P/N 32-10049).
4th axis scale not enabled
Install cable CABLE, [+5VDC) ROTARY SCALE FEEDBACK CONTROL END (CHC,NGC) (P/N 32-10049).
Mills with CHC or NGC made after October, 2016:
No change necessary.
Trunnions made before October 2016
Mills with CHC or NGC made before October, 2016:
No change necessary.
Mills with CHC or NGC made after October, 2016:
4th axis scale enabled
Remove cable CABLE, [+5VDC) ROTARY SCALE FEEDBACK CONTROL END (CHC,NGC) (P/N 32-
10049) from the control.
Install cable CABLE, [+12V] ROTARY SCALE FEEDBACK CONTROL END (NGC) (P/N 32-10053).
4th axis scale not enabled
Install cable CABLE, [+12V] ROTARY SCALE FEEDBACK CONTROL END (NGC) (P/N 32-10053).
Tools Required
Lifting Chain [1]
Spreader Beam [2]
Lifting Device [3]
Dial Indicator [4]
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On December 13, 2016 3/12