Haas TR310 - Installation Steps 10, 11, and 12; Step 10: NGC Control Configuration; Step 11: Configure 4 th Axis; Step 12: Configure 5 th Axis

STEP 11
Go to Setting 7. Set the PARAMETER to OFF.
In PARAMETER 315 enable FOURTH AXIS and FIFTH AXIS.
Change setting 30 4TH AXIS ENABLE to NEW.
Push [ENTER].
Select the correct rotary model and axis.
Note: For example, if the nameplate is TR210 Ver. P4, select
TR210-P4-TLT.
Push [ENTER].
Note: On some machines, not all rotary models are available on
setting 30 4TH AXIS ENABLE.
If your rotary model is not available, you must select USER1 for the A
axis.
Use a parameter list to enter all the A-Axis parameters . If you do not
have a parameter list, speak to your Haas Factory Outlet (HFO).
STEP 12
Change Setting 78 5TH AXIS ENABLE to NEW.
Push [ENTER].
Select the correct rotary model and axis.
Note: For example, if the nameplate is TR210 Ver. P4, select
TR210-P4-ROT.
Push [ENTER].
Note: On some machines, not all rotary models are available on
setting 78 5TH AXIS ENABLE.
If your rotary model is not available, you must select USER2 for the B
axis.
Manually enter all the B axis parameters using a parameter list. If you do
not have a parameter list, speak to your Haas Factory Outlet (HFO).
Push [POWER OFF].
Push [POWER ON].
Release [EMERGENCY STOP].
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On December 13, 2016 8/12