10
freezing compartment whenever the layer of ice/frost on the wall of the
freezing compartment reaches a quarter inch thick.
For defrosting, remove everything from the freezing compartment and put
drip tray in place. To start defrosting, set the cold control knob at the “OFF”
position. Defrosting usually takes a few hours. In order to defrost faster,
remove all items from refrigerator and keep door open.
Never use any sharp or metallic instruments to remove ice/frost from
the freezing compartment. This could puncture the evaporator
causing serious problems, and will void your warranty. DO not use
boiling water or defrost heater as it may cause damage to plastic
parts such as cabinet liner, voiding your warranty.
When defrosting is completed, remove drip tray and dispose of water. Set
the cold control knob at any desired position between “MAX” and “MIN” to
restart refrigeration.
5.5 Storage: If the incubator is to be shut down for storage or transport,
remove all items, drip tray, and shelves and screw in leveling feet. Review
Section 2.3 Lifting/Handling for transporting instructions.
5.6 There is no maintenance required for electrical components. If the unit fails
to operate as specified, please review Section 6.0 Troubleshooting, prior to
calling for service.
To Next Page
Loading...
