8
4.6 Set High Limit Thermostat: As mentioned in step 4.4, the High Limit
Thermostat should be initially set to its maximum position, to allow the unit
to stabilize. Once the incubator is stabile at the desired set point, turn the
High Limit Thermostat counterclockwise until the HIGH LIMIT light turns on.
Next, turn the Thermostat clockwise just until the light turns off. This will
set the High Limit Thermostat at approximately 1°C above main
Temperature set point.
4.7 On model 207, set the lower storage chamber control (located at the top
right back of the chamber) to a position that maintains your desired
temperature.
To Next Page
Loading...
