Hach 2100N - Preparation for Use; Unpacking; Operating Environment; Operating Power Selection

To Next Page

To Previous Page

SECTION 1, continued

1.4 Preparation for Use

1.4.1 Unpacking

After removing the instrument and accessories from their shipping box, inspect

the instrument and accessories for damage that may have occurred during

shipment due to rough handling or extreme weather conditions.

Verify the following items are present:

• Model 2100N Laboratory Turbidimeter

• Instrument Manual

• 4000-NTU Formazin Standard, 100 mL

• Standardization Kit containing Gelex Secondary Standards for Stray Light,

0–2, 0–20, 0–200, and 200–4000 ranges

• Oiling Cloth

• Seven Sample Cells

• silicone Oil, 15 mL (0.5 oz.) SCDB (Self-Contained Dropping Bottle)

• Power Cord

• Dust Cover

If any of the items are missing or damaged, please contact the Customer Service

Department, Hach Company, Loveland, Colorado. Do not return the instrument

without prior authorization. In the United States, the toll-free number is

1-800-227-4224. Outside the United States, contact your nearest Hach dealer.

1.4.2 Operating Environment

Use the turbidimeter in a clean, dust-free environment on a bench or table that is

free of vibration and that provides good air circulation around the instrument.

Keep the areas in the back and underneath of the instrument case free of materials

that could obstruct air flow through the vents.

1.4.3 Operating Power Selection

The instrument is completely assembled when shipped from the factory except for

connecting the power cable to the power cord receptacle on the rear panel. Voltage

selection for 115 or 230 Vac is done automatically.

A power cord suitable for U.S. and Canadian 115 Vac line voltage is supplied with

the Model 2100N (Cat. No. 47000-00). If this model is to be configured for

230 Vac, an approved UL/CSA power cord with NEMA 6-15P type cord cap must

be used in place of the 115 Vac power cord supplied.

The Model 2100N (Cat. No. 47000-02) is factory configured for European

230 Vac line voltage. The power cord supplied with this model is VDE approved,

and has a Continental European type plug.

Tài liệu sưu tầm của Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn

Other manuals for Hach 2100N