66
SECTION 6, continued
6.2.1 Printer Speed Selection
1. The 2100N Turbidimeter can be configured for fast or slow (2.5 second delay)
print speed.
2. Press and hold the RIGHT ARROW key for 3 seconds.
3. Use the ARROW keys to edit the display to read 01.
4. Press the ENTER key to activate the print speed selection mode.
5. Use the UP and DOWN ARROW keys to select the flashing SL Pr for slow or
FS Pr for fast print speed.
6. Press the ENTER key to accept the desired setting, and exit the print speed
configuration mode.
6.3 Using A Computer (RS232 Operating Commands)
A communication program such as Window Terminal or ProComm Plus is
recommended for computer operation. Configure the communication program to
1200 baud, 8 data bits, no parity, 1 stop bit.
The following RS232 command set is available when a computer is connected to
the 2100N:
• Key in VAL (for value) and press enter on the computer keyboard. This action
recalls the current 2100N measurement with the measurement units.
• Key in LST (for list) and press enter on the computer keyboard. This action
lists the calibration standards and coefficients.
Table 4 Dip Switch Settings for the Citizen Printer
Foreign USA Germany France UK
Character DSW1-4 OFF OFF ON ON
Selection DSW1-5 OFF ON OFF ON
ODD EVEN NO CHECK
Parity DSW1-6 OFF ON OFF ON
Check DSW1-7 OFF OFF ON ON
Data DSW1-8 ON = 7 Bit OFF = 8 Bit
9600 4800 2400 1200
Baud DSW1-9 OFF OFF ON ON
Rate DSW1-10 OFF ON OFF ON
Tài liệu sưu tầm của Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn
Tài liệu sưu tầm của Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn
To Next Page
Loading...
