SECTION 6, continued
65
Figure 22 Printer Format Example
The Citizen printer requires some configuring for compatibility with the 2100N
Turbidimeter. Set the switches and jumper positions on the Citizen Model iDP-
562RSL II printer board as follows (see Figure 23 and Table 4):
1. Set switches 6, 7, 9 & 10 to ON.
2. Set switches 1, 2, 3, 4, 5 & 8 to OFF.
3. Refer to Setting of Preset Jumper in the Citizen Printer Manual.
Figure 23 Citizen Printer Switch Configuration
Tài liệu sưu tầm của Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn
Tài liệu sưu tầm của Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn
To Next Page
Loading...
