Hach DR300 - Page 60

Category Code Value Short description Detailed description
[none] FWType (0=BL, 1=APP)
[none] Update Channel(0=factory, 1=BLE)
[none] SW Version (old)
standard
message
27 Status: completed SW-Update [Default]No further information for this event.
[none] SW Version (new)
standard
message
44 Warning: Environmental Limits
Exceeded
[Default]No further information for this event.
@1 Selfcheck
[°C] temperature
[V] battery voltage
[%] battery capacity
@2 Zero or Read too high
[°C] temperature
[V] Battery voltage
[%] battery capacity
@3 Zero/Read Difference too high
[°C] zero temperature
[°C] read temperature
[V] battery voltage
[%] battery capacity
error 108 Measurement error [DR300]Type 1 - Zero Invalid (E-14)
2 - Signal too high (E-21)
3 - Invalid freq quotient (E-22)
4 - LED error (E-2)
5 - LED error slfchk (E-2)
6 - Absorbtion too high (E-15)
[none] Type
[kHz] Dark frequency
[kHz] High frequency
[kHz] Mid frequency
[V] Battery voltage
[%] Battery capacity
[°C] Temperature
[V] LED voltage
[V] LED monitor voltage
[%] LED PWM duty cycle
[none] Absorbtion
Troubleshooting
58