Hach Flo-Dar - Operation; Install Flo-Ware Software; Set Up Logger or Station

29
Section 4 Operation
A portable computer with Flo-Ware software must be connected to the logger or station to
set up and collect data from the Flo-Dar sensor.
4.1 Install the Flo-Ware software on the PC
Procedure
1. Put the Flo-Ware CD into the CD drive on the PC.
2. Save the floware4.exe file to the hard drive on the PC.
3. Open the file to start the installation wizard and follow the on-screen instructions to
install the software.
4. Open and run the flodar.exe file. An installation wizard will start. Follow the on-screen
instructions to install the software.
4.2 Set up the FL900 Series Logger, Flo-Logger or Flo-Station
WARNING
Explosion hazard. The connection must be made to a 12 VDC battery-powered
logger or controller.
DANGER
Danger d'explosion. La connexion doit être établie avec un enregistreur ou un
transmetteur doté d'une batterie de 12 V CC.
Refer to the Flo-Ware user manual (DOC016.53.80112) for details on how to set up the
Flo-Dar sensor. The Flo-Ware user manual can be downloaded from www.Hachflow.com,
or through the Documents and manuals link in the Main screen of the Flo-Ware
software.