Hach ORBISPHERE 410 - 2.5 Default Parameters; Section 3 Installation

16
Specifications
2.5 Default parameters
The table below indicates the factory default configurations. The instrument has these settings
when started for the first time.
Parameter Default settings Customer settings
Security Disabled
Measurement
Measurement mode Continuous
Data filter Disabled
Sample phase Liquid
Units ppm-ppb
Display resolution XX.X
Storage mode Rolling buffer
Sensor Membrane 2956
Temp unit °C
Pressure unit bar
Calibration
Mode in air (O
2
, O
3
)
Hold Enabled
Analog outputs
Range 4-20 mA (0-5V)
Output Gas measurement
Extended mode Disabled
Characteristics Linear mode
Alarm relays Disabled
Thermal cutoff Enabled
Thermal cutoff temp 65°C
Calibration timer Disabled
Service timer Disabled
Buzzer
Screen tap Enabled
Alarm sound Disabled
Display
Minigraph Enabled
Temperature Disabled