18
Installation
3.2 Installation check list
To complete the installation, proceed to the following actions:
1. Follow the installation instructions in this section carefully
2. On completion, verify once more that everything is properly connected
3. Turn the instrument on
4. Set the language
5. Set the security levels, users ID’s and passwords
6. Perform a barometric sensor calibration
7. Perform the gas sensor(s) calibration
8. Perform calibration for the interferences
9. Adjust the settings for correction factors and interferences
The instrument should now be ready for operation. If a problem occurs, refer to Troubleshooting
on page 91. If the difficulty cannot be overcome, please contact your Hach Lange representative
who will be happy to assist you.
To Next Page
Loading...
