23
Installation
3.3.4 Connections (bottom of instrument)
Cable protection shield
The cable protection located at the bottom of the instrument (Figure 7 below) must be lowered,
and eventually removed, to get access to the bottom of the instrument.
Pull the plastic protection firmly towards you, then lower it as shown in Figure 8 below. To
remove it completely, push it back against the wall. Proceed in reverse order to install the cable
protection. Make sure the 4 pins are securely in place.
Front panel door
A square key is provided to open the instrument front panel locks. The two locks are located on
the right side of the instrument on the top and bottom panels (number 9 in Figure 9 below).
The front panel can be easily pivoted to the left as shown in Figure 8 below. To retain the
instrument waterproof tightness, make sure the seal is clean and in good condition before
closing the front panel.
Note: The type of power cable connection will vary depending on the instrument specification.
Figure 7 Cable protection shield in place
Figure 8 Cable protection shield lowered Figure 9 Wall/pipe mount connection panel
1 - Power cable 6 - External pressure sensor connection
2 - USB-B 4 pin connector (reserved for
manufacturing)
7 - Input/Output 2 cable gland
3 - Ethernet cable gland 8 - Input/Output 1 cable gland
4 - Sensor connection 9 - Keylock
5 - USB-A host connector for mass storage device
To Next Page
Loading...
