Hach ORBISPHERE 510 - ORBISPHERE Flow Chambers

37
Installation
3.10.2 ORBISPHERE flow chambers
Note: This is the recommended option for the K1200 sensors.
The ORBISPHERE flow chambers are used to draw the calibration sample past the sensor.
They connect to 6-mm or ¼" stainless steel tubing by means of two Swagelok fittings. If
necessary, copper or plastic tubing with low permeability can be substituted.
Dimensions of sensor and flow chamber assembly :
• Width: 50 mm
• Height: 210 mm
(add 100 mm for connection length)