42
User Interface
4.2.5 Identification and authorization level
Note: To get to level 0, press the unlock button and OK, without entering any ID or password.
4.2.6 Warning windows
Figure 31 Identification
window
Once the access rights have been set, (refer to User
management on page 84) it is necessary to log in as an
authorized user to get access to the instrument functionalities
and settings.
Press the closed padlock for two seconds to open the
identification window. The user identification and password
must be entered to access functionalities authorized by the
security level of the given user (5 levels available. Refer to
User management on page 84).
For security, when the session inactivity delay period has
expired (adjustable, refer to Configure security on page 84),
the user is logged off automatically.
Figure 32 Warnings
At various stages, a warning message may be displayed to
request confirmation from the operator that his last action(s)
must really be saved or cleared, or that there is a problem that
did not enable the requested action, such as during
instrument calibration (example shown left).
To Next Page
Loading...
