Hach sensION+ DO6 - 4 Start-Up; General Information; Keyboard and Display

8
4. Start-up
4.1. General information
Important note: before start-up, make sure that the sensor is connected to the measuring instrument.
Fig. 4. Keypad description
Display
1 Measured DO values (mg/L or %).
2 Temperature.
3 Measuring time (hh:mm:ss).
4 Units of measurement.
5 Battery indicator.
Keypad
- Instrument on/off.
- Display light on.
- Start of measuring.
- Start of calibration.
- Selection of temperature units.
- Entry of numerical values during
set-up.
5
4
4.2 User interface and navigation
4.2.1 Keyboard and display
Figure 4 indicates the instrument keys and display.
1. Connect the sensor (if necessary) to the measuring
instrument (Fig. 3, pg. 7).
2. Turn on the instrument.
3. Perform calibration (see pg. 12-14).
4. Take measurement (see pg.10).
Note: With the instrument switched off,
- Press the
key and the instrument will begin
measuring.
- Press the
key and the instrument will begin
calibration.
Software version. Instrument
serial number.
Standby screen.
1
2
3
sensION+ DO 6_HACH_0710.indd ANG:8sensION+ DO 6_HACH_0710.indd ANG:8 14/9/10 10:51:2114/9/10 10:51:21