Setup Procedures for Cell Salvage P/N 53063-50, Manual Revision: B
4-4
If a fault is found an appropriate message with actions will be displayed:
Figure 4-3: Self-Test Failure Screen
Note: Do not load disposables until the self-test is complete.
After the system self-test the display will change to the following message:
Figure 4-4: Installing the Cell Saver Disposables
SELF TEST
UNEXPECTED SENSOR READING
To retry the test, press YES
To proceed in MANUAL mode, press MODE
Waste bag weigher
NOTICE
When disposable is loaded, press START.
DISPOSABLELOAD
NaCl
RBC
To Next Page
Loading...
