Haemonetics MCS+ Service Manual

System Description 2-15
P/N 39551-00, Rev. F
The MCS+ device stores operating parameters. These parameters may be modi-
fied through one of the two MCS+ device programming displays. The HaemoCal-
culator display contains donor/patient and collection parameters and the Modify
display contains processing parameters.
MODIFY
When the MCS+ device shows the Main Screen, pressing the MODIFY key dis-
plays the Modify Parameters screen. To scroll through parameters, press the
MODIFY key when the Modify Parameters or HaemoCalculator screen is dis
-
played.
SAVE
When the Modify Parameters screen is displayed, pressing the SAVE key saves
all parameter settings on the screen.
HELP/HAEMOCALCULATOR
The HELP/HAEMOCALCULATOR key is used to obtain additional information.
In normal operation, pressing HELP/HAEMOCALCULATOR once results in the
display of the full procedure statistics of the HaemoUpdate screen. Pressing
HELP/HAEMOCALCULATOR a second time shows the HaemoCalculator dis
-
play, which contains the donor/patient statistics and procedure collection
targets.
YES/+
The YES/+ key is used to confirm a selection or to increase a selected variable in
the HaemoCalculator or Modify modes.
NO/-
The NO/- key is used to cancel a selection or to decrease a selected variable in
the HaemoCalculator or Modify modes.
PROTOCOL CARD
The Protocol Card contains the operating program for an MCS+ device protocol.
The Protocol Card is inserted through a slot inside the Protocol Card door on the
right side of the cabinet (Figure 2-10). This arrangement makes it simple to up
-
grade or change the MCS+ device program(s).

Haemonetics MCS+ Specifications

General

Brand	Haemonetics
Model	MCS+
Category	Medical Equipment
Language	English