What to do if my Haier Washer stops for a while during the cycle?
If your Haier Washer stops for a period of time during the cycle, it could be due to several reasons: the appliance might be displaying an error code, there might be a problem due to the load pattern, or the program might be performing a soaking cycle. Consider display codes, reduce or adjust the load, or cancel the program and restart it.
Why does my Haier HW70-12829 Washer stop mid-cycle?
If your Haier Washer stops before completing the wash cycle, it is likely due to a water or electric failure. Check the power and water supply.
Why does my Haier HW70-12829 keep draining while filling?
If your Haier Washer is draining while it's filling, it's likely because the drain hose is not properly installed or the drain hose end is reaching into the water. Ensure that the drain hose is properly installed and is not in water.
Why is my Haier Washer not filling with water?
Your Haier Washer might not be filling with water due to several reasons: there may be no water supply, the inlet hose could be kinked or blocked, the water pressure might be too low, the door might not be properly closed, or there could be a water supply failure. To resolve this, check the water tap, inspect the inlet hose for kinks or blockages, unblock the inlet hose filter, verify the water pressure, ensure the door is properly closed, and confirm the water supply is working.
Why is my Haier HW70-12829 Washer not spinning?
If your Haier Washer isn't spinning, it's likely due to an unbalance of laundry. Check the machine load and laundry, and then run a spinning program again.
What to do if my Haier HW70-12829 isn't draining properly?
If your Haier Washer is experiencing drainage failure, it could be because the drain hose is blocked, the pump filter is blocked, or the drain hose end is higher than 100 cm above the floor level. You should unblock the drain hose, clean the pump filter, and ensure that the drain hose is properly installed.
Why is my Haier HW70-12829 vibrating so much during spinning?
Excessive vibration in your Haier Washer during spinning can be caused by a few things: the transportation bolts might not have been removed, the appliance might not be on a solid surface, or the machine load might be incorrect. To fix this, remove all transportation bolts, ensure the washer is on solid, level ground, and check the load weight and balance.
General| Load Capacity | 7 kg |
|---|---|
| Spin Speed | 1200 RPM |
| Energy Efficiency Class | A+++ |
| Loading type | Front Load |
| Width | 60 cm |
| Noise Level (Wash/Spin) | 58/78 dB |
| Color | White |
Covers safety checks before first use and precautions for safe daily operation.
Essential safety guidelines for installing, maintaining, and cleaning the washing machine.
Steps for starting a wash cycle, managing its progress, and actions after completion.
Solutions for various washing machine malfunctions, with and without error codes.
Guidance on placing, levelling the machine, and connecting water and drain hoses.
Instructions for safely and correctly connecting the appliance to the electrical supply.
To Next Page
