- 41 -
1.2.4.3.2 Indoor
After setting unit No., record unit model
and No , fill these information in
"additional refrigerant charging list"
refer to the unit No.
setting chart
SW03 and SW02 of
indoor unit are all at "OFF"
set address manually
set address automaticlly(setting
state when out of factory)
Indoor address setting
if some indoor are electrified
individually, please rectify,
shield layer should be grounded
on outdoor at single point
confirm indoors in one system are electrified
accordantly, signal wire shielded layer of all
indoor and outdoor units is connected together,
and is grounded on outdoor at single point
wired controlled slave unit: pull out
CN23, SW01: 1-15,
（ should not
repeated in one group
） , B,C of
terminal block to wired controller,
short connect CN30, SW08-[6] at
"ON"
， that is setting state when
out of factory
pull out the short connection wire
CN23,CN3,SW08-[6] at "OFF",
CN21 to remote reciever
wired controlled master unit:
set state when out of factory
(CN23
、 CN30 short connected,
SW08-[6] at "ON"; SW01 at
"0"), terminal block A,B,C
to wired controller
wired control type remote control type
choose indoor controller
Part 2
To Next Page
Loading...
