Haier MRV II - Indoor Parameters

1.3.5 Dip switch on inverter board
Part 3
SW1-1
SW1-2
inspection of operation
without load
0
1
SW1-3
SW1-4
SW1-5
SW1-6
cannot run without load, set when out of factory
communication failure
alarm with connecting
board serial port
0
1
can run without load
pre-set
0
1
set as OFF when out of factory
pre-set
set as OFF when out of factory
alarm, set when out of factory
not alarm, set when out of factory
pre-set
0
set as OFF when out of factory
SW2-1
SW2-2
SW2-3
SW2-4
pre-set
pre-set
pre-set
pre-set
pre-set
0
0
0
0
0
set as OFF when out of factory
set as OFF when out of factory
set as OFF when out of factory
set as OFF when out of factory
set as OFF when out of factory
1.4 Indoor parameters
SW10
0-15
control description
LED2, LED3, LED4 display air inelt temp. -2 degree displays -02
LED2, LED3, LED4 display air inelt temp. -2 degree displays -02
LED2, LED3, LED4 display valve open angle
LED3, LED4, display indoor capacity, 1.5HP displays 1.5
display indoor failure code; no failure, display 0
LED3, LED4, indoor available, display 1111; indoor unavailable, display ----
function
indoor communication checking
indoor abnormal
indoor capacity
air inlet temp.
indoor gas pipe temp.
indoor EEV open angle
SW11
3
4
5
6
7
8
9
SW9
0
1
2
3
address
1-16
17-32
33-48
49-64
indoor liquid pipe temp.
LED2, LED3, LED4 display air inelt temp. -2 degree displays -02
10-15
pre-set
- 98 -