Part 1
4.1 Wall mounted unit installation
installation figure:
mounting plate
gas pipe
liquid pipe
indoor side
outdoor side
through-wall hole
wall thickness
through-wall hole section
adhesive tape
fresh air pipe
heat insulation
4.1.1 Fix the mounting plate, set the through-wall hole: install the unit on
smooth wall beside beam and pillar. Firstly , fix the mounting plate on the
wall with a steel nail ,use a thread with a screw ,drop it down vertically
from the central top of the mounting plate,(or you can use a gradienter)to
find the horizontal place and fix it. Drill holes in the wall according to the
wall mounting plate’s position , put plastic sleeve into the hole, then
fasten the plate securely with 4*25 screw .
4.1.2 Make through-wall hole : make a throughout hole in the wall , after
installation , please seal it with putty or gesso.
4.1.3 Hang the unit body onto the upper notches of the mounting
plate ,move the body from side to verify its secure fixing.
- 9 -
To Next Page
Loading...
