14 49-5000477 Rev. 0
• You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the
humidity is high. This design feature helps remove moisture and improve efficiency.
• You may hear the thermostat click when the compressor cycles on and off.
• Water will collect in the base pan duringhigh humidity or on rainy days. The water may overflow and drip from the outdoor
sideof the unit.
• The fan may run even when the compressor does not.
• Water droplets being thrown against the outside coils can make a pinging noise. This helps cool the condenser. You can
reduce this noise by removing the subbase water plug.
To ensure maximum efficiency it is recommended to check to ensure the rubber drain plug is properly inserted. This plug
may be removed during operation to minimize water in the back of the unit; however, removing it will lower the efficiency
of your unit.
NOTE: Do not drill hole in the base pan.
Subbase Water Plug
NORMAL OPERATING SOUNDS
To Next Page
Loading...
Need help?
General
