Operation
Air Flow Direction Adjustment
1.Adjusting the flap
Status display of air flow:
When restart after remote turning off, the remote
Move the vertical blade by a knob on air conditioner
to adjust left and right direction.
2.Left and right air flow adjustment (manual)
Cautions:
When adjusting the flap by hand,turn off the unit.
When humidity is high,condensate water might occur
It is advisable not to keep horizontal flap at downward
position for a long time in COOLor DRY mode ,
otherwise, condensate water might occur.
Emergency Operation:
at air outlet if all vertical louvers are adjusted to left or
right.
controller will automatically memorize the previous
Note:
set swing position.
Use this operation only when the
remote controller is defective or lost.
When the emergency operation
switch is pressed, the" Pi "sound is
heard once, which means the start
of this operation.
In this operation, the system
automatically selects the operation modes, cooling or
fan or heat, according to the room temperature.
When machine is running in emergency, the set value
of temperature and wind speed couldn't be altered;
meanwhile, it can't operate for dehumidifying or under
timing mode.
Pi
When SWING is selected, the flap swinging range depends
on the operation mode.(See the figure.)
When adjusting by hand, the mechanism may not opera-
te properly or condensation may drip from air outlets.
When adjusting the flap by hand, turn off the unit, and use
the remote controller to restart the unit.
Do not try to adjust the flap by hand.
Confirming your setting
After setting correct time, press button to confirm
" "or" "on the remote controller stops flashing.
Time displayed: Unit starts or stops at x hour.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset. Remote controller possesses
memory function, when use TIMER mode next time, just
press button after mode selecting if time setting is
the same as previous one.
TIMER On/Off Operation
Timer On/Off On-Off Operation
(Auto swing)
Pos.1
Pos.2 Pos.3
Pos.4
Pos.5
Pos.6
COOL/DRY
HEAT
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
BLANK
TIMER ON TIMER OFF TIMER ON-OFF
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). " "or " "will flash.
3.Press / button to set time.
It can be adjusted within 24 hours.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be achieved.
TIMER OFF-ON
0.5h
0.5h 0.5h
0.5h
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first
12 hours decreased by 0.5 hour every time, after 12
hours,decreased by 1 hour every time.
After adjust the time,press button and confirm the
time ON or OFF button will not flash any more.
4.Confirm timer setting
5.Cancel timer setting
Press the timer button by times until the time display
eliminated.
System configuration
Domestic air conditioner
To Next Page
Loading...
