Hakko Electronics FM-2023 User Manual

®
MINI PARALLEL REMOVER
Instruction Manual
●
Thank you for purchasing the FM-2023 mini parallel remover.
Please read this manual before operating the FM-2023. Keep this
manual readily accessible for reference.
●
CAUTION
• The FM-2023 cannot function by itself. It must be connected to an
FM-202 soldering station.
• Specific information can be found in the instruction manual for your
FM-202 soldering station.
TABLE OF CONTENTS
1. PACKING LIST .........................................................1
2. SPECIFICATIONS ....................................................
1
3. WARNINGS, CAUTIONS AND NOTES ...................
2
4. PART NAMES ...........................................................
3
5. SETTING UP THE FM-2023 ....................................
3
6. OPERATION .............................................................
4
7. MAINTENANCE .......................................................
7
8. TROUBLESHOOTING GUIDE .................................
8
9. PARTS LIST ...........................................................10
10. WIRING DIAGRAM ................................................11
11
10. WIRING DIAGRAM
HEAD OFFICE
4-5, SHIOKUSA 2-CHOME, NANIWA-KU, OSAKA, 556-0024 JAPAN
TEL:+81-6-6561-3225 FAX:+81-6-6561-8466

http://www.hakk
o.com
AMERICAN HAKKO PRODUCTS, INC.
28920 N. AVENUE WILLIAMS VALENCIA CA 91355, U.S.A.
TEL: (661) 294-0090 FAX: (661) 294-0096

Toll Free (800)88-HAKKO www.hakkousa.com
4 2 5 5 6
2005.12
MA01234JZ051219
P.W.B/LED
W
hite
Red
Black
Green
S
-
LED1
+
Yellow
Blue
Brown
Purple

Hakko Electronics FM-2023 Specifications

General

Brand	Hakko Electronics
Model	FM-2023
Category	Power Tool
Language	English

Summary

Warnings, Cautions, and Notes

High Temperature Safety Precautions

Precautions for handling hot tips to prevent burns, fire, and damage.

Unit Safety and Operating Precautions

Guidelines to prevent unit damage and ensure safe operation, including proper usage and ventilation.

Setting Up the FM-2023

Making Connections

Operation

Display Indicators and Sequence

Operating Instructions

Setting the Temperature

Instructions for setting the tip temperature, including maximum limits and recommended values for normal work.

Using the Handle Lever

Replacing the Tip

Inserting the Tip

Maintenance

Checking Procedures

Verifying Heater and Sensor Integrity

Steps to check for a broken heater or sensor by measuring resistance across the tip.

Checking the Grounding Line

Checking the Connection Cord

Troubleshooting Guide

Tip Does Not Heat Up

Troubleshooting steps for when the tip does not heat up, including sensor errors.

Low-Temperature Alarm Error [H-E]

Solder Does Not Wet the Tip

Tip ID Error [E-E]

Troubleshooting steps for Tip ID errors, including manual entry and tip compatibility.

Tip Temperature Too High

Heater Terminal Short Circuit Error [HSE]

Troubleshooting for heater terminal short circuit errors.

Tip Temperature Too Low

Tips Cannot Be Closed

Soldering Iron Error [E-E]

Troubleshooting for the [E-E] error display and non-lighting heater lamp.

General Tip Error Display

Troubleshooting for general tip errors displayed on the unit, recommending contact with a representative.

Wiring Diagram