20
Maintenance and Service
5 Maintenance and
Service
General information
It is essential to pay attention
to the information in Chapter
"Sa
fety Information" before
completing any service or
maintenance work!
By adhering to the maintenance work
reco
mmended by us, you can be sure
that the machine is always ready to be
put into operation.
Maintenance and repair work neces-
sary on a daily and weekly basis can be
carried out by an operator trained to
complete the work, all other Hako sys-
tem maintenance may only be complet-
ed by personnel who are
correspondingly qualified and trained.
Please contact your nearest Hako ser-
vice center or Hako authorized dealer.
Failure to observe this annuls any rights
to claims under the terms of guarantee
in respect of resulting damage or con-
sequential damage.
Always specify the serial number in the
case of inquiries and spare parts or-
ders, refer to section 1.7 - Rating plate.
5.1 Hako system maintenance
The Hako system maintenance:
• ensures that the Hako machine is al-
ways ready for operation (preventive
main
tenance),
• minimizes operating costs, mainte-
nance and repair costs,
• ensures the machine has a long ser-
vice life.
Hako system maintenance provides in-
divi
dual modules explaining the special
technical work to be carried out and
prescribes the intervals at which the
work should be performed. Parts to be
replaced for the individual maintenance
tasks are defined and provided in spare
parts kits.
Hako system maintenance, cus-
tomer
Work to be carried out by the customer
accordi
ng to the service and mainte-
nance instructions in the operating
manual (daily and weekly). The driver/
operator receives proper instruction
when the machine is delivered.
Hako system maintenance I:
(every 125 operating hours)
Completed by technical experts from an
authorized Hako service center in ac-
cordance with the specific machine sys-
tem maintenance using spare parts kits.
Hako system maintenance II:
(every 250 operating hours)
Completed by technical experts from an
authorized Hako service center in ac-
cordance with the specific machine sys-
tem maintenance using spare parts kits.
Hako system maintenance III/S:
(every 500 operating hours, safety
check -
at least once a year)
Completed by technical experts from an
authorized Hako service center in ac-
cordance with the specific machine sys-
tem maintenance using spare parts kits.
Completion of all legally prescribed,
safety-related tests in accordance with
UVV-BGV-TÜV-VDE
To Next Page