FAQ
Q1:
A1：
Q3:
A3：
Q2:
A2：
Q4:
A4：
Q6:
A6：
Q5:
A5：
No sound of kick drum.
Check “KICK” type in UTIL and select relatively, refer to Page 13.
The “Save” symbol appears in the lower right corner of main interface.
Factory Reset, refer to Page 13.
Adjusting the volume of pad.
Adjust “Volume” parameter in effect interface, refer to Page 11.
Customizing the drum kit.
Enter voice interface and select relatively pad, refer to Page 4. Or use “Coarse” and “Fine” in effect interface to
adjust the sounds, refer to Page 11.
There is no reaction of pad when hitting in trigger or effect interfacet.
To set “Auto Trace” as “ON” in MIDI interface, then back to check in trigger or effect interface, refer to Page 10.
Adjusting the brightness of sound module.
Adjust brightness by “CTRL” parameter in system interface, refer to Page 13.
No reaction of sound module when connecting external MIDI device.
Adjust the relatively parameter in MIDI interface: setting relatively “Channel No.”, “USB MIDI OUT” as “ON” and
“USB MIDI IN” as “ON”, refer to Page 10.
Insufficient volume of rim shot.
Adjust “Rim Gain” parameter in trigger interface, refer to Page 10.
To avoid the cross of rim and head.
Adjust “Head Rim” parameter in trigger interface, refer to Page 10.
To avoid the cross of pads.
Adjust “AntiCross” parameter in trigger interface, refer to Page 9.
To prevent double triggering (two sounds instead of one).
Adjust “Mask Time” parameter in trigger interface, refer to Page 9.
Adjusting the sensibility of pad.
Adjust “Sensibility” parameter in trig interface, refer to Page 7.
Q7:
A7：
Q9:
A9：
Q10:
A10：
Q12:
A12：
Q11:
A11：
Q8:
A8：
To Next Page
Loading...
Need help?
General