H&S 6128 - SET-UP & ASSEMBLY

SET-UP & ASSEMBLY
NOTE: Determine right or left side of the Merger by viewing it from the rear. If instructions or parts lists
call for hardened bolts, refer to bolt torque chart.
• Check the Merger for proper assembly and adjustment. Make sure that all bolts are tightened.
Securely retighten after a few hours of operation as bolts can loosen up on new machinery.
• If the merger was shipped w/o the rims/tire assemblies attached, Attach the rims/tire assemblies,
using the lug nuts furnished. Torque the mounting hardware to correct torque specication. Check
the wheel bolts periodically thereafter.
• Check tires and inate to the recommended pressure. (15R19 x19.5 Radial Tires = 70 PSI)
• Lubricate the Merger completely (Refer to the Lubrication section in this Manual).
-17-