H&S GM 170 - Page 40

LUBRICATION
-38-
Flywheel (1 zerk)
Transfer Auger Rear
Bearings(2 remote zerks
on rear of frame)
Transmission Output Shaft
Collar(1 remote zerk on
rear of frame)
Transmission Input Shaft
Bearing(1 remote zerk on
rear of frame)
Top of Mixing Auger
(1 zerk - under top
of tank cover)
Unloading Auger Pivot/Collar
(4 zerks - 2 on the top of
the collar & 2 on the
bottom of the collar)
Unloading Auger-(1 zerk at the end
of the auger discharge spout)
Unloading Auger(1 zerk on the
top of vertical section auger and
4 zerks on vertical auger pivot.)
SIA Upper Pivot Bearing
(1 zerk)
SIA Lower Pivot Bearing
(1 zerk)
Auger/Transmission Main
Shear Bolt(1 zerk)
Oil level should be between
Max/Min level marks
Telescoping PTO Drive (3 zerks)
*Front & Rear Mill Bearings
(2 zerks)
*Main Shaft Slider Bearings
(2 zerks)
*Transfer Auger Front Bearing
(1 zerk)
(All zerks are remote in Grease
Bank under main shaft shield)
Overrunning Clutch
(1 zerk)