Hangar 9 Super Stick - Additional Equipment Required; Tools and Supplies Required

ADDITIONAL EQUIPMENT REQUIRED
TOOLS AND SUPPLIES REQUIRED
➤ Equipment Needed
4 Channel Transmitter (minimum)
5 Standard Servos
Standard 450–650 mAh Receiver Battery Pack
2 Aileron Extensions and/or 1Y-harness
➤ Note: If more than a 4-channel radio is used,
than Y-harness is not necessary.
Super Stick 40:
.40–.46 2-Cycle Engines
.45–.56 4-Cycle Engines
Super Stick 60:
.61–.75 2-Cycle Engines
.65–.80 4-Cycle Engines
➤ Engine Recommendations
➤ Recommended JR Systems
JR F400 FM (Optional Y-harness required)
JR XF642FM
JR XP783
JR XP8103
(5 servos required)
➤ Recommended 2-Cycle Engines
Super Stick 40:
Thunder Tiger Pro .40
Thunder Tiger Pro .46
Thunder Tiger .42 Sport
Webra Speed .40 Sport
Super Stick 40:
Saito .50
Saito .50GK
Saito .56
Saito .56GK
Super Stick 60:
Thunder Tiger Pro .60
ASP .61
ASP .75
Super Stick 60:
Saito .65
Saito .65GK
Saito .80
Saito .80GK
➤ Adhesives
Thick CA (cyanoacrylate) glue
6-minute epoxy
30-minute epoxy
Blue Locktite 242
➤ Tools
Drill
Drill bits:
1/16 " ,3/32 ” ,5/32 "
Phillips screwdrivers
Z-bend pliers
Pliers
Small round file
Moto-tool
with sanding drum
Hobby knife
with #11 blade
Mixing stick
Epoxy brush
90 d T i l
Medium sandpaper
Masking tape
Straight edge
Measuring devices
(ruler,tape measure,
90˚ triangle)
Scissors
Paper towels
Wax paper
Rubbing alcohol
Felt tipped pen
Fuel tubing
Clips (clothes pins,
bi d li )
➤ Recommended 4-Cycle Engines
Thunder Tiger .61Thunder Tiger .40
Saito .50 Saito .65