1313
2 2 Safety Safety RulesRules
1)1)
Only trained and authorized operatorOnly trained and authorized operator
shall be permitted to operate the forklift.shall be permitted to operate the forklift.
2)2) Operator must wear helmet, workingOperator must wear helmet, working
shoes and uniformshoes and uniform
3)3) It is not allowed to reconfigure the truckIt is not allowed to reconfigure the truck
without manufacturer’s permissionwithout manufacturer’s permission
..
4)4) Do not work in flammable andDo not work in flammable and
combustible combustible environmeenvironment.nt.
5)5) Check the oil, fluid leakage, deformation,Check the oil, fluid leakage, deformation,
flexibility in certain time. If neglected,flexibility in certain time. If neglected,
service life of forklift will be shorter and inservice life of forklift will be shorter and in
serious condition there will be serious condition there will be accident.accident.
––
Make sure change the “safety parts”Make sure change the “safety parts”
during the schedule maintenance.during the schedule maintenance.
–– Wipe off the oil, grease or water on theWipe off the oil, grease or water on the
soleplate, foot pedal and control stick.soleplate, foot pedal and control stick.
––
No smoking or any spark, smoke near theNo smoking or any spark, smoke near the
battery when checking.battery when checking.
–– Be careful of scald when checking motorBe careful of scald when checking motor
and controller.and controller.
6)6) The controller equips with energyThe controller equips with energy
accumulator, do not touch between B+accumulator, do not touch between B+
and B- to avoid electric injury. If you needand B- to avoid electric injury. If you need
check or clean the controller, connectcheck or clean the controller, connect
load(like load(like contactor contactor coil coil or or horn) horn) betweenbetween
controller B+ and B- to discharge thecontroller B+ and B- to discharge the
controller capacity.controller capacity.
7)7) Whenever you find the forklift abnormal,Whenever you find the forklift abnormal,
stop the truck, put on the DANGEROUSstop the truck, put on the DANGEROUS
or FAULT sign to the truck, remove theor FAULT sign to the truck, remove the
key, and report to the managing person.key, and report to the managing person.
Only after eliminating the fault can youOnly after eliminating the fault can you
use the truck.use the truck.
–– If there occurs to fault, battery electrolyte,If there occurs to fault, battery electrolyte,
hydraulic oil or brake fluid leakage whenhydraulic oil or brake fluid leakage when
lifting loads, going up and down lifting loads, going up and down the slope,the slope,
please organize staff to repair.please organize staff to repair.
8)8) Internal battery may generate explosiveInternal battery may generate explosive
gas, it’s prohibited any flame close thegas, it’s prohibited any flame close the
battery. Never allow the tools close twobattery. Never allow the tools close two
poles of the battery to avoid spark orpoles of the battery to avoid spark or
short circuit.short circuit.
9)9) The work ground of forklift shall be solidThe work ground of forklift shall be solid
and smooth concrete surface or similarand smooth concrete surface or similar
ones. Pre-check the ground condition ofones. Pre-check the ground condition of
working site. Tidy the working site, cleanworking site. Tidy the working site, clean
obstacle, sweep macadam, muddy sandobstacle, sweep macadam, muddy sand
and wipe off greasy dirt.and wipe off greasy dirt.
10)10) Do not overload. Before operation, firstDo not overload. Before operation, first
know the curve chart on the load curveknow the curve chart on the load curve
plate well, which indicates the relationplate well, which indicates the relation
To Next Page
Loading...
