6060
WARNINGWARNING
No broken wire sheath, or No broken wire sheath, or else the circuit might be damaged.else the circuit might be damaged.
Do not process the locating surface or the holes of the production withoutDo not process the locating surface or the holes of the production without
authorization, or else the magnet loop would authorization, or else the magnet loop would be influenced.be influenced.
Do not over press when fitting the motor shaft. Make sure no damage on the Do not over press when fitting the motor shaft. Make sure no damage on the frictionfriction
surface and wipe off the burr of the mounting holes and surfaces. Put the shaftsurface and wipe off the burr of the mounting holes and surfaces. Put the shaft
sleeve on the motor shaft and fasten the axial sleeve on the motor shaft and fasten the axial clamp spring.clamp spring.
Measure the direct voltage of the connecting brake and compare the value to theMeasure the direct voltage of the connecting brake and compare the value to the
rated voltage on the nameplate. Deviation should not be more than 10%.rated voltage on the nameplate. Deviation should not be more than 10%.
Make sure it is free from oil and Make sure it is free from oil and dirt when installing and using the brake.dirt when installing and using the brake.
OILOIL
U=x V DC±10%U=x V DC±10%
1.5.3 Maintenance1.5.3 Maintenance
–– Avoid rusting WAvoid rusting When truck hen truck is is used in used in a a high temperature for high temperature for a a long time. long time. The The actuation sideactuation side
with rust would with rust would affect the performance.affect the performance.
––
Do not touch the Do not touch the friction surface with your hand directlyfriction surface with your hand directly. Make sure . Make sure it is fit is free from oil and dirt,ree from oil and dirt,
or else the maximum torque could not be achieved.or else the maximum torque could not be achieved.
–– Generally the working environment temperaturGenerally the working environment temperature is e is around -10around -10℃～℃～+40+40℃℃..
Conduct a periodical inspection. It concludes the items as follow. Is it smooth to switch? Is thereConduct a periodical inspection. It concludes the items as follow. Is it smooth to switch? Is there
any noise or any abnormal heating? Is there any dirt or grease that came to the section of frictionany noise or any abnormal heating? Is there any dirt or grease that came to the section of friction
and rotation? Whether the gap is appropriate between the frictions? Any problem with theand rotation? Whether the gap is appropriate between the frictions? Any problem with the
exciting voltage ?exciting voltage ?
To Next Page
Loading...
