5959
1.5.2 Electromagnetic brake installation1.5.2 Electromagnetic brake installation
–– Put the flat key (13) into the key groove of the motor shaftPut the flat key (13) into the key groove of the motor shaft
(9). Press the shaft sleeve (4) to the motor shaft (9) and(9). Press the shaft sleeve (4) to the motor shaft (9) and
fasten it with fasten it with the inner spring.the inner spring.
––
Install the friction disk (5) to the end face of the motor byInstall the friction disk (5) to the end face of the motor by
using three mounting bolts of the friction bolts (12).using three mounting bolts of the friction bolts (12).
–– Cover the shaft sleeve with the friction disk (3).Cover the shaft sleeve with the friction disk (3).
––
Install the stator module (2) to the friction disk (5) with threeInstall the stator module (2) to the friction disk (5) with three
mounting bolts of the brake (1).mounting bolts of the brake (1).
Note: Remove the three rubber mats of the stator moduleNote: Remove the three rubber mats of the stator module
which is for stable transportation.which is for stable transportation.
–– Screw down the three mounting bolts (1) with a torqueScrew down the three mounting bolts (1) with a torque
wrench (15) and check the air gap (Z) of the brake with awrench (15) and check the air gap (Z) of the brake with a
feeler gauge (16).feeler gauge (16).
–– Put on Put on the dustproof cover(6).the dustproof cover(6).
––
Connect the brake wiring.Connect the brake wiring.
1313
99
1414
44
55
1212
33
11
1616
1515
66
ZZ
To Next Page
Loading...