4444
8.5 8.5 Replace Replace wheelswheels
8.5.1 Replace drive wheel8.5.1 Replace drive wheel
Procedure:
Procedure:
–– Dismantle the drive unit from the truck.Dismantle the drive unit from the truck.
（（
Refer to part of Refer to part of ”dismantle the drive unit”dismantle the drive unit
from the truck”from the truck”
））
–– Remove the 12 socket hexagon screwsRemove the 12 socket hexagon screws
which is used to fix the driving wheelswhich is used to fix the driving wheels
with a S=5mm hex wrench.with a S=5mm hex wrench.
CAUTIONCAUTION
Use equal strength to unscrew theUse equal strength to unscrew the
bolts. Do not overexert which mightbolts. Do not overexert which might
do damage on the thread.do damage on the thread.
Loosen the bolts in a symmetricalLoosen the bolts in a symmetrical
way when unscrewing the bolts andway when unscrewing the bolts and
remove the bolts respectively.remove the bolts respectively.
––
Remove the fixation clamp of the motorRemove the fixation clamp of the motor
signal wire.signal wire.
–– Strike the edge of the driving wheels withStrike the edge of the driving wheels with
a rubber hammer and remove the olda rubber hammer and remove the old
driving wheels from the drive unit.driving wheels from the drive unit.
CAUTIONCAUTION
Strike the edge of the Strike the edge of the driving wheelsdriving wheels
evenly and evenly and symmesymmetrically.trically.
Do not scratch the outer surface ofDo not scratch the outer surface of
inner ring gearbox and the innerinner ring gearbox and the inner
surface of the driving wheels.surface of the driving wheels.
–– Install new driving wheels. ApplyInstall new driving wheels. Apply
lubricating oil to the lubricating oil to the outer surface of innerouter surface of inner
ring gearbox and the inner surface of thering gearbox and the inner surface of the
driving wheels in favor of fast driving wheels in favor of fast installment.installment.
https://www.besttruckmanuals.com/
To Next Page
Loading...