5353
1.2 1.2 Assemble Assemble and and use use noticenotice
––
When assemble, scrub the oil seal on the product. Avoid product damage, no disassemble atWhen assemble, scrub the oil seal on the product. Avoid product damage, no disassemble at
will.will.
–– Avoid eacAvoid each fitting surface h fitting surface and exposed and exposed gear impgear impact, thus influence act, thus influence installationinstallation..
––
Normal working oil temperature is ≤70Normal working oil temperature is ≤70
℃℃
..
––
Drive wheel is maintenance free drive device, if need grease, dismantle the drive unit, addDrive wheel is maintenance free drive device, if need grease, dismantle the drive unit, add
from the top.from the top.
–– Added amoAdded amount of greaseunt of grease(SHELL (SHELL ALALVVANIA ANIA R3) is 2/5-2/3 spR3) is 2/5-2/3 space of the inace of the inner chamberner chamber..
1.3 1.3 Fault Fault and and troubleshootingtroubleshooting
Fault Fault Probable Probable cause cause Corrective Corrective actionaction
AbnormaAbnormal l gear gear noise noise whenwhen
travellingtravelling
Over Over large large gear gear clearance clearance AdjustAdjust
Lack Lack grease grease ReplenishReplenish
Over Over large large gear gear wear wear ReplaceReplace
AbnormaAbnormal noise when tul noise when turningrning
Rotary Rotary rolling rolling bearing bearing damage damage ReplaceReplace
Insufficient rotary rolling bearingInsufficient rotary rolling bearing
greasegrease
Add greaseAdd grease
Brake ineffective or invalidBrake ineffective or invalid
Inching switch loosen orInching switch loosen or
damagedamage
Fasten or replaceFasten or replace
Over Over large large brake brake clearance clearance AdjustAdjust
Brake Brake disc disc over over wear wear ReplaceReplace
Brake Brake loosen loosen FastenFasten
Circuit Circuit damage damage RepairRepair
Large Large vehicle vehicle vibration vibration Damper Damper assembly assembly damage damage ReplaceReplace
To Next Page
Loading...