HANGCHA CBD20-AEC1 - Braking Braking; Steer Steering Ing; Stopp Stopping Ing; Loading Loading



3333
6.4 Braking6.4 Braking
–– When the thumb off the direction speed control button, pull the handle to braking range (B1 orWhen the thumb off the direction speed control button, pull the handle to braking range (B1 or
B2) position or vertical postion, the truck brakes.B2) position or vertical postion, the truck brakes.
CAUTIONCAUTION

 When release the control handle, the handle swivel into the braking range slowly orWhen release the control handle, the handle swivel into the braking range slowly or
nor enter braking range, do check the reason and eliminate the fault. Replace gasnor enter braking range, do check the reason and eliminate the fault. Replace gas
spring if necessary.spring if necessary.
6.5 Steering6.5 Steering
––
Hold the left and right handle of control handle with both hands, and decline to some degree,Hold the left and right handle of control handle with both hands, and decline to some degree,
move the handle to left or move the handle to left or right to release truck steering.right to release truck steering.
When turn to left, the truck turns left.When turn to left, the truck turns left.
When turn to right, the When turn to right, the truck turns right.truck turns right.
6.6 Stopping6.6 Stopping
–– Release the direction-speed knob. Decrease the speed.Release the direction-speed knob. Decrease the speed.
–– Return the control handle to vertical position.Return the control handle to vertical position.
––
 Drop the fork to Drop the fork to the lowest position.the lowest position.
––
Turn off the switch to “OFF” position, press down the emergency disconnect switch, pull outTurn off the switch to “OFF” position, press down the emergency disconnect switch, pull out
the battery plug, and take off the key.the battery plug, and take off the key.
––
 Fold up.Fold up.
6.7 Loading6.7 Loading
Procedure:
Procedure:
–– Drive the truck carefully up to the loads.Drive the truck carefully up to the loads.
–– Adjust fork heAdjust fork height to make the ight to make the forks are in the trforks are in the trayay..
––
 Raise the loads several centimeters to make sure if Raise the loads several centimeters to make sure if the loads are firm.the loads are firm.
https://www.besttruckmanuals.com/