90
Buckle belt bracket
a. Hold strain device with right hand, take buckle
belt with left hand, direct to the notch on ratchet
wheel
b. Pass buckle belt through the notch on ratchet
wheel.
c. Pull buckle belt downward with left hand, pull
out the lock buckle with forefinger, middle finger
and third finger in right hand, and push up to touch
cylinder at the same time.
d. Keep the buckle belt tensioning and keep the lock
buckle out, revolve strain device downward with
right hand till touch cylinder.
e. Keep it tensioning with left hand, hold the strain
device , loose lock buckle ,and rotate strain device
several times till it can not be pushed.
f. Turn downward till touch cylinder.
（5）Make sure the inlet and outlet shutoff valve （
○
2
○
3）are on closed state.
（6）Connect the inlet connector（
○
5）with outlet valve（
○
4）,and tighten.
（7）Open outlet shutoff valve slowly（
○
3）.
（8）Make sure there is no leaking before using, if there is some leaking, close outlet
shutoff valve（
○
3） in time, turn on the forklift input connector,（
○
5）。
To Next Page
Loading...